HP xw8600 and xw9400 Workstations - Nvidia Quadro FX5600 graphics card and auxiliary power adapter cable installation

Step 3—Installing the FX 5600 graphics card
NOTE: The FX 5600 graphics card occupies two slots on the system board. HP recommends that you
place the card in the primary graphics slot. To identify PCI Express slots, refer to the service label on
the workstation access panel.
1. Release the PCI retainer levers by pressing down, then out . Remove the applicable PCI slot
covers
2
.
Figure 4 Opening the retainer and removing the slot covers
2. To install the FX 5600 graphics card in the workstation, lower it into the chassis and align the card
in a groove of the card guide. Press the card securely into the PCI slot.
NOTE: For convenience, rotate the graphics card bulkhead under the rear chassis lip, and then
rotate the card into the card guide, lowering it into the slot.
Figure 5 Aligning and installing the FX 5600 graphics card
ENWW Step 3—Installing the FX 5600 graphics card 5