Owner's manual
Table Of Contents
- Title Page
- Contents
- What's New
- About This Manual
- 1 Overview of the Tape Library
- 2 Unpacking the Tape Library
- 3 Installing the Tape Library
- 4 Controls and Indicators on the CTL700 Tape Library
- 5 Configuring and Testing the Tape Library
- Overview of Configuration
- Tape Library Capacity
- Entering Configuration Data
- Performing the Final Steps
- Initialization Sequence
- Testing the Tape Library
- 6 Operating the Tape Library
- Operating in Automated Mode
- Powering Off the Tape Library
- Operating In Manual Mode
- 7 Tape Drives in the CTL700 Tape Library
- 8 Configuring the CTL700 Tape Library for the NonStop SSeries Server
- 9 Managing Tape Drives
- A Configuring the CTL700 Tape Library for the NonStop NS-Series Server
- B Configuring the CTL700 Tape Library for the NonStop SSeries Server With the IOAM Enclosure
- C Configuring the CTL700 Tape Library for the NonStop BladeSystem Server
- Safety and Compliance
- Index
Overview of the Tape Library
L700 (CTL700) Installation and User’s Guide—527338-008
1-4
Software
Software
For support of the tape library connection to a NonStop server, you can use either:
•
The independent product, Silo Media Manager (SMM).
•
The Storage Tek UNIX server software, Automated Cartridge System Library
Software (ACSLS). You must have a minimum of Sun Solaris 8 and ACSLS 6.0.
SF02 is also required to allow ACSLS to run on a NonStop server.