Owner's manual
Table Of Contents
- Title Page
- Contents
- What's New
- About This Manual
- 1 Overview of the Tape Library
- 2 Unpacking the Tape Library
- 3 Installing the Tape Library
- 4 Controls and Indicators on the CTL700 Tape Library
- 5 Configuring and Testing the Tape Library
- Overview of Configuration
- Tape Library Capacity
- Entering Configuration Data
- Performing the Final Steps
- Initialization Sequence
- Testing the Tape Library
- 6 Operating the Tape Library
- Operating in Automated Mode
- Powering Off the Tape Library
- Operating In Manual Mode
- 7 Tape Drives in the CTL700 Tape Library
- 8 Configuring the CTL700 Tape Library for the NonStop SSeries Server
- 9 Managing Tape Drives
- A Configuring the CTL700 Tape Library for the NonStop NS-Series Server
- B Configuring the CTL700 Tape Library for the NonStop SSeries Server With the IOAM Enclosure
- C Configuring the CTL700 Tape Library for the NonStop BladeSystem Server
- Safety and Compliance
- Index
Unpacking the Tape Library
L700 (CTL700) Installation and User’s Guide—527338-008
2-4
Physically Unpacking the Tape Library
Physically Unpacking the Tape Library
You will need diagonal cutters or a knife to cut the shipping straps. Refer to Figure 2-3
while unpacking:
1. Remove and retain the shipping bill.
2. While holding the shipping ramp against the tape library box covers, carefully cut
the wrapping straps on the exterior of the packaging.
3. Remove the ramp and corrugated box covers.
4. Remove the shipping bag (not shown).