Owner's manual
Table Of Contents
- Title Page
- Contents
- What's New
- About This Manual
- 1 Overview of the Tape Library
- 2 Unpacking the Tape Library
- 3 Installing the Tape Library
- 4 Controls and Indicators on the CTL700 Tape Library
- 5 Configuring and Testing the Tape Library
- Overview of Configuration
- Tape Library Capacity
- Entering Configuration Data
- Performing the Final Steps
- Initialization Sequence
- Testing the Tape Library
- 6 Operating the Tape Library
- Operating in Automated Mode
- Powering Off the Tape Library
- Operating In Manual Mode
- 7 Tape Drives in the CTL700 Tape Library
- 8 Configuring the CTL700 Tape Library for the NonStop SSeries Server
- 9 Managing Tape Drives
- A Configuring the CTL700 Tape Library for the NonStop NS-Series Server
- B Configuring the CTL700 Tape Library for the NonStop SSeries Server With the IOAM Enclosure
- C Configuring the CTL700 Tape Library for the NonStop BladeSystem Server
- Safety and Compliance
- Index
Contents
L700 (CTL700) Installation and User’s Guide—527338-008
iv
A. Configuring the CTL700 Tape Library for the
NonStop NS-Series Server
Programming and Configuration Considerations 9-17
Choosing Block Size 9-17
Using a Tape Drive for a Tape Boot or Tape Load 9-17
A. Configuring the CTL700 Tape Library for the NonStop NS-
Series Server
Fibre Channel ServerNet Adapter Connection A-1
Configuring the SCSI Control Path A-2
Configuring Fibre Channel Tape Drives A-3
Configuring the NonStop NS-Series Server to the CTL7FC Fibre Channel Interface
Card A-9
Adding the Control Path A-11
B. Configuring the CTL700 Tape Library for the NonStop
S-Series Server With the IOAM Enclosure
Configuration Overview B-1
Adding the Control Path and Data Path B-1
C. Configuring the CTL700 Tape Library for the NonStop
BladeSystem Server
Configuration Overview C-1
Adding the Control Path and Data Path C-1
Start the Tape Library and Tape Drive C-2
Verify the Tape Configuration C-2
Troubleshoot the Tape Configuration C-3
Safety and Compliance
Index
Examples
Figures
Figure 1-1. The CTL700 Tape Library 1-1
Figure 2-1.
Space Needed for CTL700 Tape Library 2-2
Figure 2-2.
Power and Signal Cable Routing 2-3
Figure 2-3. Unpacking the Tape Library 2-5
Figure 2-4. Column Shipping Pin 2-7
Figure 2-5. Theta Shipping Pin 2-8
Figure 2-6. Z Column Movement 2-9
Figure 2-7.
Moving the Z Carriage Assembly 2-10