Manual

Silo Media Manager Installation and Users Guide
Hardware and Software Installation for the Client
3-27
3.9 Stopping the Processes on the Client
To stop the processes on the Client, return to a TACL prompt. Volume over to the
location where the Client files have been installed. Type “O STOPALL” at the TACL
prompt to stop the processes. A screen like Figure 3-24 will display.
Figure 3-24 “STOPALL” Command on the Client
To verify all the processes have stopped, type “O STATUS” at the TACL prompt to
view all of the files again and make sure they have all stopped. If nothing is returned,
all the processes have stopped. If a status has returned on any one or all the
processes, then the files have not been stopped.