User guide

Actions
Abort Backup Path
Terminates operation of the backup path to the disk. When the Abort action finishes, the path is in a
Hard Down state. You must use the Reset Backup Path action before you can start the path again.
Abort Disk
Terminates operation of the all paths for the disk. When the Abort action finishes, the paths are in a
Hard Down state. You must use the Reset Disk action before you can start the paths again.
Abort Primary Path
Terminates operation of the primary path to the disk. When the Abort action finishes, the path is in
the Stopped state.
Reset Backup Path
Places the backup path in a state from which it can be started.
Reset Disk
Places the disk in a state from which it can be started. This action might be necessary if the disk was
in a STOPPED state, substate HARDDOWN; a hardware error has occurred; the disk was stopped
with an ABORT command; or if a STOP or ABORT fails to put the disk into the STOPPED state,
substate DOWN.
Reset Primary Path
Places the primary path in a state from which it can be started.
Reset Volume
Places the volume in a state from which it can be started.
Responsive Test
Verifies that the disk drive is installed and responding.
Start Backup Path
Starts the backup path to this disk drive. When the Start action completes, the backup path is in the
started State.
Start Disk
Starts all paths to this disk drive. When the Start action completes, all paths are in the Started state.