Owner manual

IP Address The IP address of the service processor.
Current Topology
The maximum processor configuration for the service processor. Values
Device State
The state of the service processor:
Active (Primary): This is the master service processor and is available.
Active (Secondary): This is the not master service processor, but it is
available.
Firmware Update Mode: An SP firmware update is in progress.
In Test: Temporary state during power-on self-test.
Initializing: Temporary state during startup.
SP Stopped Responding to Peer
Fabric Side Values: X or Y
SP Firmware
Version The VPROC of the firmware currently loaded on the service processor.
Default File Name
The name of the file to be used for the service processor firmware update.
(SPCODE9)
Default File Version The version of the firmware to be used for a firmware update.
Compare State
The differences, if any, between the current and default firmware versions.
Values
SCSI Boot Code Firmware
Version
The version of the firmware running on the SCSI controller on the PMF CRU
that contains the service processor.
Default File Name The name of the file to be used for the SCSI Boot Code firmware update.
Default File Version
The version of the firmware to be used for the SCSI Boot Code firmware
update.
Compare State
The differences, if any, between the current and default firmware versions.
Values
Processor Boot Millicode Firmware
Version
The version of the firmware on the processor on the same PMF CRU with this
service processor.
Default File Name
The name of the file to be used for the Processor Boot Millicode firmware
update. (CPUCODE9)
Default File Version
The version of the firmware to be used for the Processor Boot Millicode
firmware update.