Owner manual

Hardware Revision
A code that identifies the generation of the component. Hardware revision
codes are used for tracking components.
Logical
Link State
The status of the Ethernet link.
Values: Up, Down, Not Available
Duplex Mode
The duplex mode of the connection between the logic board and the router.
Values: Half Duplex, Full Duplex, Not Available
Maximum Speed
The maximum speed of the connection between the logic board and the router.
Values: 10Mbps, 100Mbps, Not Available
Board State
The operational status of the SWAN 2 LAN logic board CRU.
Values: OK, Fault, Not Available
Actions
None.
SWAN Line
A subcomponent of SWAN CLIPs and SWAN 2 CLIPs. Every CLIP has two lines, which represent
the ports on the CLIP.
Location in OSM Tree: System > SWAN Collection > SWAN > CLIP > Line
Example: Line $ZZWAN.#SWAN2.1.0
Attributes
Line $ZZWAN
Service State
Displayed in the Attributes tab and Attributes dialog box only if attention or service is
required. Values
Logical
DLC Task Name
The name of the data link control (DLC) task associated with the line.
Format: adapter name.clip number.DLC line number
Example: $ZZWAN.#D08XE5.1.DLC0