Owner manual

Enable Automatic Data Collection
Changes the Automatic Data Collection State attribute value to Enabled, thus enabling automatic
collection of data for failed system resources, provided the data collection volume, as specified by
the Set Data Collection Volume action, is available. Supported resources include PMF, IOMF,
SEB/MSEB, Battery, Fan, Power, Disk, Tape, SNDA, FXSA, and SWAN.
To disable automatic collection of data, use the Disable Automatic Data Collection action.
Extend Problem Incident Report Suppression Time
Extends the duration of suppression by a specified amount of time (in minutes). This action fails if
the suppression was not enabled at that time.
Rediscover System
Causes OSM to refresh and reanalyze all components within the system.
Rediscover System and ServerNet Cluster
Causes OSM to refresh and reanalyze all components within the system and the ServerNet cluster.
Use this action in situations such as:
Set Data Collection Volume
Used to specify a volume in which automatic or manual data collection will take place. The volume
should be something other than $SYSTEM to avoid the possibility of filling that volume with
collected data.
The Diagnostic Data Collection Volume attribute displays the currently specified volume.
By default, the collected (PAK) files are deleted after 30 days. You can alter the number of days
before they are deleted through the RETAINDAYS parameter in your OSMCONF file. For
information on creating an OSMCONF, or adding this parameter to an existing OSMCONF, see the
OSM Migration Guide.
Suppress Problem Incident Report Creation
This action, which can be initiated by a user or guided procedure, suppresses the creation of Problem
Incident Reports for the default time of 40 minutes. The default value can be changed in the
OSMCONF file or extended for an action currently in progress by using the Extend Problem Incident
Report Suppression Time action. Performing this action while the system is already in the suppressed
state resets the duration of the current suppression to the default time.
Unsuppress Problem Incident Report Creation
Removes suppression caused by the Suppress Problem Incident Report Creation action. While this
suppression is automatically unsuppressed when the specified suppression time has been reached,