Owner's manual

Chapter Five - SCSI Bridge Electronics
5.12.2 Configuring the options setting
If your configuration or host environment requires unique settings or special configurations, HP
can provide assistance and firmware configurations for specific platforms, software, or drives
through the use of this menu item. This setting is configured at 00001400 and should not be
changed by the user. As described, special situations may require that this setting be changed, but
you should consult the GCSC for technical assistance before changing this setting. Use the
Numeric Entry Method to enter the 8-digit hex value.
Options
00001400
PRESS to
Done
Options
00001400
PRESS to
Alter
Options
00001200
PRESS to
Alter
Figure 36 Options setting
5.12.3 Selecting a Baud rate
Four different baud rates are available for connecting to a serial terminal or terminal emulator.
Other communication parameters are: No parity, 8 data bits, 1 stop bit and
xon/xoff flow control. The 3-pin serial connector on the back of the unit allows connection
to a PC serial port by using an extension cable. A communication package such as PRO-
COMM (with xon/xoff enabled) allows you to upgrade the flash firmware serially. Select a
baud rate by using the Pick Entry method.
BaudRate
9600 bps
PRESS to
Alter
BaudRate
19K2 bps
PRESS to
Done
BaudRate
2400 bps
PRESS to
Scroll
BaudRate
1200 bps
PRESS to
Scroll
Figure 37 Baud rate
5.13 Setup 3 Offline Utilities Display Format Items
Hdwr
Test
PRESS to
Run
Enter
Set-Up 3
PRESS to
Select
Drive
Test
PRESS to
Run
Exit
Set-Up 3
PRESS to
Select
Load a
CodeTape
PRESS to
Run
Create a
CodeTape
PRESS to
Run
Figure 38 Setup 3 configuration items
HP StorageWorks DAT 72 (Model 5242-2SE) User's Guide 24 HP Part Number 528297-003 July 2005