Owner's manual

Chapter Six – Maintenance
6.1 5242-2SE Tape Path Cleaning
The Media Caution LED is located on the front panel of the tape drive. When it flashes amber, the
tape heads are dirty and should be cleaned.
DRIVE B DRIVE A
Tape Drive
LEDs
Mode
Switch
Eject
Button
Display
Unit
Display
LEDs
LCD
Figure 45 5242-2SE Media Caution LED
Warning The tape heads must be cleaned regularly. Use the recommended cleaning schedule
as specified per cartridge type. See the Table 6.
Recommended Cleaning Schedules for
125m DDS-3 and 170m DAT72 Tape Cartridges
Number of DDS
cartridges used
each day
1 2 3 4 or more
Recommended
cleaning frequency
8 weeks 4 weeks 3 weeks weekly
Table 6 Cleaning schedule for the 5242-2SE using DDS-3 or DAT72
tape cartridges
6.1.1 Using the Cleaning Cartridge
Note: To prevent contamination of the unit and damage to the heads, do not use the cleaning
cartridge for more than the manufacturer's specified number of cleaning cycles; and do
not attempt to rewind the material in the cleaning cartridge and reuse it.
1. Insert the cleaning cartridge into the drive. The drive automatically takes the cartridge, loads it,
and cleans the heads. After about 30 seconds, the drive ejects the cartridge.
Note
: If the cartridge ejects after 15 seconds, the cartridge has reached the end of its useful
life, and no cleaning has occurred. The Cleaning Needed LED might still be lit so
discard the cartridge and repeat the cleaning operation with a new cleaning cartridge.
2. Take the cartridge out of the drive. Write the date on the label of the cleaning cartridge to
provide a record of how many times it has been used. Do not use the cleaning cartridge more
times than specified by the manufacturer.
HP StorageWorks DAT 72 (Model 5242-2SE) User's Guide 29 HP Part Number 528297-003 July 2005