Owner manual

SCSI Boot Code Firmware
These attributes are displayed only for SPs located in PMF or PMF2 CRUs; not for those in IOMF or
IOMF2 CRUs.
Version
The version of the firmware running on the SCSI controller on the PMF CRU
that contains the service processor.
Default File Name The name of the file to be used for the SCSI Boot Code firmware update.
Default File Version
The version of the firmware to be used for the SCSI Boot Code firmware
update.
Compare State
The differences, if any, between the current and default firmware versions.
Values
Processor Boot Millicode Firmware
These attributes are displayed only for SPs located in PMF or PMF2 CRUs; not for those in IOMF or
IOMF2 CRUs.
Version
The version of the firmware on the processor on the same PMF CRU with this
service processor.
Default File Name
The name of the file to be used for the Processor Boot Millicode firmware
update. (CPUCODE9)
Default File Version
The version of the firmware to be used for the Processor Boot Millicode
firmware update.
Compare State
The differences, if any, between the current and default firmware versions.
Values
Actions
Processor Boot Millicode Firmware Update
Updates the Processor Boot Millicode firmware for a single service processor (SP).
Available only for SPs on PMF and PMF2 CRUs.
Optional Parameter: File Namethe name of the Processor Boot Millicode firmware file on the
local node.
Syntax: $volume.subvolume
Default value: $SYSTEM.SYSnn
Reset
Causes the service processor (SP) to reload the service processor operating image from the FLASH
PROM.
If the CLCI and CNSL (console) sessions of OutsideView are running through an SP that is reset, the