Owner manual

Enable Drive Bypass
Shuts down the specified port or ports (A and/or B) on the disk drive.
Firmware Update
Updates firmware for the Fibre Channel disk drive. This action can be performed only when both
Primary and Backup paths are in the Down state.
Replace
Displays the procedure for replacing the disk.
Reset Backup Path
Places the backup path in a state from which it can be started.
Reset Disk
Places the disk in a state from which it can be started. This action might be necessary before starting
a disk that has both paths in a Hard Down state; for example, if a hardware error has occurred, if the
disk was stopped with an Abort action, or if a Stop or Abort fails to put the disk into the Down state.
If only one disk path is in a Hard Down state, you can use the Reset Primary Path or Reset Backup
Path as appropriate.
Reset Primary Path
Places the primary path in a state from which it can be started.
Reset Volume
Places the volume in a state from which it can be started.
Responsive Test
Verifies that the disk drive is installed and responding.
Save as System Load Configuration
Specifies, within OSM, this disk as an alternate system load volume. You can specify up to four such
alternate system load configurations. Each one is displayed under the system attributes in the OSM
Service Connection and can be selected from within the System Load dialog box in the OSM
Low-Level Link.
Spin Down
Stops the physical spinning of the disk drive. This should be done before removing a disk drive. Both
paths must be down for the action to succeed.