Owner's manual

5157/5157 ACL S-Series DLT Subsystems Installation Users Guide
Operating the 5157 ACL Tape Drive 6-13
6.8 Entering the Menu Mode
Important Note: When the Enter button is pressed to enter the
Menu Mode, the Ready light goes out. This means that the module
is offline, and the module responds to all SCSI commands from the
host by reporting Not Ready until the Menu Mode is exited and the
Ready light goes on.
To prevent inadvertent interruption of host operations, the Menu
Mode may be locked out using the Security Menu. See the
subsection 6.10.10 Security Menu. When the control panel is
locked, the unlock code must be entered in order to display the
Main Menu. Note that the Show Status Menu remains accessible. It
may be displayed from the Default Screen at any time by pressing
the Escape button.
When the Default Screen appears on the screen, enter the Menu
Mode can be entered by pressing the Enter button. The Main Menu
shown in Figure 6-8 appears.
÷÷Load/Unload
Unlock Door
Show Status Menu
Maintenance Menu êê
Figure 6-8 Main Menu
Note: If the Control Panel is locked, the screen shown in Figure 6-
9 appears instead of Figure 6-8. The unlock code for the specific
5157 ACL must be known before proceeding. If the code is
unknown, contact the system administrator.