Owner's manual

5157/5157 ACL S-Series DLT Subsystems Installation Users Guide
Operating the 5157 ACL Tape Drive 6-34
From:From:
÷÷DLT1DLT1
To:To:
*Slot *Slot êê
Figure 6-27 Load/Unload ‘From’ Entry Screen
Press the Enter button to select DLT1. Notice that in Figure 6-28,
two changes occur in the display:
• The Q reappears at the beginning of line 2, indicating that a selection
has been made.
• The ÷ now moves to line 4, indicating that a destination has been
selected.
From:From:
*DLT1*DLT1
To:To:
÷÷*Slot *Slot êê
Figure 6-28 Load/Unload ‘To’ Entry Screen
Now simply press the Enter button to select Slot2 as the
destination. Note that there is an ê at the end of line 4. There are
additional choices available because 1) a drive has been selected as
the source, so the destination must be a slot, and 2) All of the slots
except Slot1 are empty, so below Slot2 there is a list of the
remaining empty slots. Instead select Slot4. Press the ü button
repeatedly until Slot4 appears on line 4. Press the Enter button to
select Slot4. In response, the confirmation screen in Figure 6-29
appears.