Owner's manual

5157/5157 ACL S-Series DLT Subsystems Installation/Users Guide
Installing and Configuring the 5157/5157 ACL Digital Linear Tape Subsystem
for S-Series Servers
7-7
7.3.2.1 Copper SCSI Cable (PMF CRU Only)
The Cable used to connect the tape drive CRU to the PMF CRU is
a copper SCSI cable.
One end of the cable has a 68 -pin connector with latch-clip flanges
that connects to the uncapped SCSI port at the rear of the tape
drive CRU. The other end of the cable has a 68-pin connector with
thumbscrews that connects to the SCSI passthrough terminator on
the PMF CRU differential SCSI port.
Note: The SCSI passthrough terminator is pre-installed on the
differential SCSI port.
Caution
Do not use an MFC-style copper cable for connecting a tape drive CRU to
a PMF
Table 7-1 Copper SCSI Cables for the 5157/5157 ACL
Digital Linear Tape Subsystems
Part Number Description
424360-001 (1 meter) copper SCSI cable
424361-001 10-feet (3 meter) copper SCSI cable
424362-001 50-feet (15 meter) copper SCSI cable
424917-001 65-foot (20 meter) copper SCSI cable
424363-001 75-foot (23 meter) copper SCSI cable