Owner's manual

5157/5157 ACL S-Series DLT Subsystems Installation/Users Guide
Installing and Configuring the 5157/5157 ACL Digital Linear Tape Subsystem
for S-Series Servers
7-17
Example 3: Deleting a Tape Drive From the System
Use the SCF DELETE TAPE command to delete a tape drive from
the system configuration database.
Before issuing the DELETE command, use the SCF STATUS
command to verify that the tape drive is in the stopped state. For
example:
->STATUS TAPE $TAPE0
STORAGE - Status $TAPE $TAPE0
Ldev State SubState Primary Backup
DeviceState
PID PID
20 STOPPED 0, 30 1, 30
If the STATUS command shows that the tape drive is not in the
STOPPED state, use the SCF STOP command to place the tape
drive in the STOPPED state. For example:
>STOP TAPE $TAPE0
The following example removes tape drive $TAPE0 from the
system configuration:
->DELETE TAPE $TAPE0
Use the INFO command to verify that the tape drive has been
removed from the system:
->INFO $TAPE*
For more information on the STATUS, DELETE, and INFO
commands, see the SCF Reference Manual for the Storage
Subsystem.