Owner's manual

The 5157/5157 ACL S-Series Subsystems Installation/Users Guide
Installing and Configuring the 5157 Tape Drive 3-7
Figure 3-6 Rear Panel Components
3.5.2 Connect the SCSI Signal Cable
To connect the SCSI signal cable:
1. Connect one end of the SCSI cable to the rightmost SCSI signal
connector on the 5157 rear panel.
2. Secure the cable with the hand tightening screws.
3. Connect the other end of the SCSI cable to the SCSI connector
on the system, or for daisy-chained configurations, connect the
other end of the SCSI cable to the next SCSI device.
See the system documentation for system SCSI connections.