Owner's manual

5157/5157 ACL S-Series DLT Subsystems installation Users Guide
Installing and Configuring the 5157 ACL Tape Subsystem 5-3
Figure 5-2 Rear View
5.3 Configure the 5157 ACL Tape Subsystem
This section describes how to configure the 5157 ACL drive. For
information on the different menu’s and submenu’s featured on the
5157 ACL Tape Subsystem, refer to Chapter 6, “Operating the 5157
ACL Tape Subsystem.”
The 5157 ACL library controller is factory set to SCSI ID 3; the
5157 ACL drive is factory set to SCSI ID 5, unless otherwise
specified. The drive is factory set for parity generation and checking
is enabled.