Owner's manual

5157/5157 ACL S-Series DLT Subsystems installation Users Guide
Installing and Configuring the 5157 ACL Tape Subsystem 5-5
÷÷ Set Data Format
Set SCSI
Set Library Mode
Set Element Base ê
Figure 5-5 Configure Submenu
4. To select a configuration option, press the ù or ü button on
the control panel until the ÷ on the display is next to the option
to change. In this case choose Set SCSI. Press the Enter button
to display the choices for that option. The submenu in Figure 5-
6 appears.
÷÷ Library Parity:
*Enabled
Library Bus ID:
*3 ê
Figure 5-6 Set SCSI Submenu
Note: Take a moment to look closely at the submenu in Figure 5-6.
Note that the ÷ on the display is next to line 1, and that line 2 is
indented. This says that Figure 5-5 is a two-tiered menu. The ù and
ü buttons work on two levels in this kind of menu, which is typical
of many submenus of the Configure Menu. The first level is as
follows: If the ü button is pressed, the ÷ moves to line 3. Pressing
the ü button again will scroll down to ‘DLT Bus ID.’ If the ù
button is pressed, the ÷ moves back to line 1.
If the Enter button is pressed while the ÷ is next to line 1 (or line
3), the ù and ü buttons operate on the second level. It is obvious
because the ÷ moves next to line 2 (or line 4), and a êê appears at
the end of line 4, indicating that there is a list of settings that can be
scrolled using the ù and ü buttons.