Owner's manual

5157/5157 ACL S-Series DLT Subsystems installation Users Guide
Installing and Configuring the 5157 ACL Tape Subsystem 5-7
5.4 Connect the Cables
5.4.1 Examine the 5157 ACL Rear Panel
Examine the components on the 5157 ACL rear panel to complete the
physical installation (see Figure 5-8).
Figure 5-8 Rear Panel Components
5.4.2 Connect the SCSI Signal Cable
To connect the SCSI signal cable:
1. Connect one end of the SCSI cable to the leftmost SCSI signal
port on the 5157 ACL rear panel.
2. Secure the screws on each side of the connector.
3. Connect the other end of the SCSI cable to the SCSI connector
on the system, or for daisy-chained configurations, connect the
cable to the next SCSI device.