Owner's manual

5157/5157 ACL S-Series DLT Subsystems installation Users Guide
Installing and Configuring the 5157 ACL Tape Subsystem 5-11
5.6 Descriptions of Configuration Options
The items available on the Configuration Menu are described in the
following subsections.
5.6.1 Set Data Format:
This setting enables the user to set the data format and enable or
disable data compression. The data format options are: Auto
Selection, THZ01, THZ02, DLT2000, DLT2000XT, DLT4000 or
DLT7000. Compression can not be enabled when either THZ01 or
THZ02 format is in use. This setting applies to the next or the
currently loaded cartridge only. An unload command returns to the
default. This setting does not display the format of the loaded tape.
Use the Show Status Menu for this purpose. The defaults are Auto
Selection for both density and compression.
5.6.2 Set SCSI:
This setting enables the user to enable or disable the robotics SCSI
bus parity checking and set the SCSI addresses of the drives and the
robotics. The defaults are: parity on; DLT 1 Bus ID = 5; Library
Bus ID = 3.