Owner's manual

5157/5157 ACL S-Series DLT Subsystems installation Users Guide
Installing and Configuring the 5157 ACL Tape Subsystem 5-13
5.6.5 Set Identification:
This setting enables to specify the response of the 5157 ALC’s
robotics to the SCSI Inquiry command in the Vendor ID and the
Product ID fields. The defaults are: Vender ID = TSI; Product ID =
515X.
5.6.6 Set Date:
This setting enables the user to set the module’s calendar.
5.6.7 Set Time:
This setting enables the user to set the module’s clock.
5.6.8 Set Baud Rate:
This setting enables the user to set the data transmission rate of the
module’s trace port. This function is intended for use by CE’s only.
The default is 38400 bits/sec.
5.6.9 Set Serial number:
This setting enables the user to alter the 5157 ACL’s serial number
as stored in the unit. The 5157 ACL’s robotics reports these
settings in response to the SCSI Inquiry command in the Unit Serial
Number Page.
5.6.10 Set Unload Mode:
This setting determines whether a SCSI Move Medium command is
interpreted as implicit or explicit. If implicit, the module unloads a
drive before attempting to move a cartridge from that drive. If
explicit, the host must issue a SCSI Unload command to a drive
before each Move Medium command that removes a cartridge from
that drive. The default is Implicit.