User guide

Path B
Configured Controller Location
The location of FCSA connected to the disk drive through Port B.
Example: FCSA.FSAC-1.GRP-111.MOD-2.SLOT-1
Fibre Channel Controller
Identifies the FCSA FSAC connected to the FCDM through Port B.
Example: FCSA FSAC (111.2.1.1)
Path A
Configured Controller
Location
The location of FCSA connected to the disk drive through Port A.
Example: FCSA.FSAC-1.GRP-111.MOD-2.SLOT-1
Fibre Channel Controller
Identifies the FCSA FSAC connected to the FCDM through Port A.
Example: FCSA FSAC (111.2.1.1)
Actions
Blink All LEDs Off
Turns off the blinking of the fault LEDs on the FCDM, disks, FC-AL I/O module, power supplies,
and fans.
Blink All LEDs On
Causes the fault LEDs on the FCDM, disks, FC-AL I/O module, power supplies, and fans to blink.
Disable All Drive Bypass
Opens up the specified port or ports (A and/or B) on all disk drives in the FCDM for use.
Enable All Drive Bypass
Shuts down the specified port or ports (A and/or B) on all disk drives in the FCDM.
Replace
Displays the procedure for replacing the FCDM.
Set Physical Location
Allows you to assign these Physical Location attributes for the FCDM:
Rack Name is a user-defined name for the rack containing the FCDM. You can enter up to
eight alphanumeric characters.
●
Rack Offset is a numerical value representing the location of the FCDM within the rack. A
valid integer must be specified when performing the Set Physical Location action, or the
●