User guide

connectivity between specified processor on this Internal Fabric. You can specify one or all
processors. The action will report any ServerNet errors between the specified processor(s) and all
other processors in the system.
Start ServerNet
Starts all ServerNet traffic through all or specified processors on the fabric.
Stop ServerNet
Stops all ServerNet traffic through all or specified processors on the fabric.
IOAM (I/O Adapter Module)
Attributes
Actions
A modular I/O adapter module. There are two IOAMs in each IOAM Enclosure.
Each IOAM contains:
A ServerNet Switch Board●
Two IOAM Power Supplies●
Two IOAM Fans●
Up to five FCSA or G4SAs●
IOAMs are initially configured using the Configure Module action in the OSM Low-Level Link, as
described in the NonStop NS-Series Hardware Installation Manual (available in the Hardware
Service and Maintenance collection of NTL).
IOAM names in OSM include the group number and a module number of either 2 or 3. For example,
IOAM 13.2 is located in group 13, module 2. The other IOAM in this IOAM group is IOAM 13.3.
Note: If for any reason a ServerNet switch board is not present in a module, the fans, power
supplies, and adapters in that module will not appear in OSM.
Location in OSM Tree: System > Group > IOAM Enclosure > IOAM
Example: IOAM 13.2
Attributes
Physical
Hardware Revision
A code that identifies the generation of the component. Hardware revision
codes are used for tracking components.