User guide

Note: On T0682AAC and later, this OSM action is also supported on Telco systems.
Tests fault tolerance of the power environment within the module. If the results of the action indicate
a problem, check the Power State attribute of the individual CRUs to determine where the problem
lies.
This action is run automatically at 2:00 a.m. daily. It can also be performed manually at any time.
Set Physical Location
Allows you to assign these Physical Location attributes for the module:
Rack Name is a user-defined name for the rack containing the module. You can enter up to
eight alphanumeric characters.
●
Rack Offset allows you to display a numerical value representing the location of the module
within the rack. A valid integer must be specified when performing the Set Physical Location
action, or the action will fail.
●
Locator is an optional text string to help identify the physical location of the module. It must
contain alphanumeric characters only.
●
Alarm Panel Identifier is used for Telco systems only.●
Monitored Service LAN Devices
Attributes
Actions
Contains Maintenance Switch and UPS objects that you have configured OSM to monitor through
the actions on this object.
Location in OSM Tree: System > Monitored Service LAN Devices
Attributes
None.
Actions
Start Monitoring Maintenance Switch
Causes the OSM Service Connection to display and start monitoring the maintenance switch. You
are prompted to enter a User ID and Password (which are established by the administrator during
initial configuration of the maintenance switch), the IP address of the maintenance switch, and a
name (must be between 1 and 60 characters; OSM displays this name as part of the maintenance
switch object name).