User guide

multifunction I/O board ( MFIOB), and the power supply subassembly.
processor multifunction (PMF) 2 CRU
A NonStop S-series customer-replaceable unit ( CRU) that contains a power supply,
service service processor (SP), ServerNet router 2, Ethernet controller, three ServerNet
addressable controllers ( SACs), and a processor and memory system in a single unit. The
PMF 2 CRU consists of three subassemblies: the processor and memory board ( PMB),
the multifunction I/O board ( MFIOB), and the power supply subassembly.
Q
There are no entries for this section
R
reanalyze
An action that runs the OSM incident analysis, which checks EMS event messages and
creates alarms in OSM if certain conditions exist.
See also refresh.
refresh
An action that updates the attribute values displayed in the OSM Service Connection
interface.
See also reanalyze.
remote access
A form of remote support. Remote access, or dial-in, allows a remote service provider to
dial in to your server to diagnose hardware and software problems.
Remote access and remote notification are not available in countries where the modem
provided by HP is not certified. In these countries, you cannot use OSM to dial out to or
accept dial-in communications from a service provider.
See also remote notification.
remote notification
Remote notification, or dial-out, allows OSM to notify a service provider, such as the
Global Customer Support Center (GCSC), of pending hardware and software problems.
Remote access and remote notification are not available in countries where the modem
provided by HP is not certified. In these countries, you cannot use OSM to dial out to or
accept dial in communications from a service provider.
See also remote access, incident report, and notification.