User guide

Configured FSAC
Location
Displays the configured location of the FCSA FSAC containing the backup
disk path controller. This attribute is displayed even if the physical FCSA
FSAC is not present.
Example: FCSA.SAC-1.GRP-111.MOD-3.SLOT-2
FSAC
Identifies the backup FCSA that manages the disk.
Example: FCSA FSAC (111.3.2.1)
Firmware
OEM Product ID The firmware product ID assigned by the supplier.
Version The version of the firmware running on the disk.
Actions
Abort Backup Path
Terminates operation of the backup path to the disk. When the Abort action finishes, the path is in a
Hard Down state. You must use the Reset Backup Path action before you can start the path again.
Abort Disk
Terminates operation of the all paths for the disk. When the Abort action finishes, the paths are in a
Hard Down state. You must use the Reset Disk action before you can start the paths again.
Abort Primary Path
Terminates operation of the primary path to the disk. When the Abort action finishes, the path is in a
Hard Down state. You must use the Reset Primary Path action before you can start the path again.
Blink LED Off
Turns off the blinking of the disk drives (amber) fault LED.
SCF Equivalent: SCF Control SAC $ZZSTO.#sac-name, deviceid(shelf,bay), LED OFF
Blink LED On
Causes the disk drives (amber) fault LED to blink on and off.
SCF Equivalent: SCF Control SAC $ZZSTO.#sac-name, deviceid(shelf,bay), LED ON
Clear Data
Erases all data on the disk but leaves the disk label intact. Clear Data does not erase the FIR data in
the CE sector, the volume label, the boot sector, or the spare tracks table. After a Clear Data
completes or is cancelled, the disk drive is not usable until you restore the file system by using the
SCF command Alter Label.