Owner's manual

Backup Path
An identification number assigned to the device when configured.SCSI ID
A number (1 or 2) that identifies the backup SCSI controller that manages the disk.
Example: SCSI Controller (1.1.50.2)
SCSI Controller
The accessibility of the backup path.
Values: Inactive, Active
Access State
The location of the backup disk path SCSI controller.
Example: IOMF2.SAC-2.GRP-1.MOD-1.SLOT-55
Configured Controller Location
Primary Path
An identification number assigned to the device when configured.SCSI ID
A number (1 or 2) that identifies the primary SCSI controller that manages the disk.
Example: SCSI Controller (1.1.50.2)
SCSI Controller
The accessibility of the primary path.
Values: Inactive, Active
Access State
The location of the primary disk path SCSI controller.
Example: IOMF2.SAC-2.GRP-1.MOD-1.SLOT-50
Configured Controller Location
Firmware
The version of the firmware running on the disk.Version
Actions
Abort Backup Path
Terminates operation of the backup path to the disk.When the Abort action finishes, the path is in a Hard Down state.
You must use the Reset Backup Path action before you can start the path again.
Abort Disk
Terminates operation of all paths for the disk. When the Abort action finishes, the paths are in a Hard Down state.
You must use the Reset Disk action before you can start the paths again.
Abort Primary Path
Terminates operation of the primary path to the disk. When the Abort action finishes, the path is in the Stopped state.
BLINK LED Off
Stops the blinking of the fault LED initiated by the Blink LED On action.
BLINK LED On
Causes the fault LED to blink to make it easier to identify the component.
Clear Data
Erases all data on the disk but leaves the disk label intact. Clear Data does not erase the FIR data in the CE sector,
the volume label, the boot sector, or the spare tracks table. After a Clear Data action completes or is cancelled, the
disk drive is not usable until you restore the file system by using the SCF Alter Label command.
Firmware Update
Updates disk drive firmware.
Reset Backup Path
Places the backup path in a state from which it can be started.
External Disk 117