Owner's manual

Storage ASIC
The status of the storage ASIC in the CRU.
Values: Initialized, Uninitialized, Unknown
Initialization State
Actions
Disable ServerNet Port
Disables the specified ServerNet port on this CRU. Perform this action only as directed by OSM alarm repair actions.
Parameter: Port Number
Enable ServerNet Port
Enables the specified ServerNet port on this CRU. Perform this action only as directed by OSM alarm repair actions.
Parameter: Port Number
Force Power Off
This action is not supported for this CRU type. See the Prepare to Power Off action.
Power Off
This action is not supported for this CRU type. See the Prepare to Power Off action.
Prepare to Power Off
Performs precautionary check to make sure that you can safely remove the CRU.
The precautionary check makes sure that the other IOMF2 CRU in this enclosure exists and is powered on.
If the check confirms that you can safely power off the CRU, these preparatory steps are performed:
• If the SP on this IOMF2 is designated as Active (Primary), resets the SP so that the peer SP becomes primary
• Disables the battery
If the Prepare to Power Off action completes successfully, you can safely remove the CRU.
If the check fails, the Prepare to Power Off action fails, and you should perform the steps using other OSM actions
before removing the CRU.
Replace
Launches the Replace IOMF guided procedure, which provides step-by-step instructions for replacing the IOMF2
CRU.
Storage ASIC Initialization Test
Prompts the storage subsystem manager process ($ZZSTO) to initialize the storage ASIC in the CRU. If initialization
fails, an alarm is generated.
This action is triggered automatically when a new CRU is inserted while OSM is running or when an (SCF) STATUS
ADAPTER command is issued. If a CRU is inserted while OSM is not running, perform this action after logging on to
the OSM Service Connection.
Test Verify
Performs basic tests on the CRU.You can perform this action when the CRU is online.
IOMF2 (I/O Multifunction 2) 151