Owner's manual

SWAN LAN Logic Board (LANLB)
Each SWAN 2 CRU has two customer-replaceable LAN logic board subcomponents.
Location in OSM Tree: System > SWAN Collection > SWAN > LANLB
Example: LAN LB $ZZWAN.#SWAN2.LAN1
Attributes
LAN LB $ZZWAN
Displayed in the Attributes tab and Attributes dialog box only if the value is something
other than OK. Values
Service State
Physical
The part number of the component that was assigned in manufacturing. Use part
numbers for identifying and ordering parts.
Part Number
A unique serial number that identifies the component.Track IDs are used for tracking
components.
Track ID
A code that identifies the generation of the component. Hardware revision codes are
used for tracking components.
Hardware Revision
Logical
The status of the Ethernet link.
Values: Up, Down, Not Available
Link State
The duplex mode of the connection between the logic board and the router.
Values: Half Duplex, Full Duplex, Not Available
Duplex Mode
The maximum speed of the connection between the logic board and the router.
Values: 10Mbps, 100Mbps, Not Available
Maximum Speed
The operational status of the SWAN 2 LAN logic board CRU.
Values: OK, Fault, Not Available
Board State
Actions
None.
202 System Resources