Owner's manual

Installing and Configuring the Nomadic Disk
Manager
ServerNet Nomadic Disk User’s Guide—425485-001
3-15
Nomadic Disk Manager Configuration Statements
SET VOL Statement
The SET VOL statement modifies the segment template to be used by a subsequent
ADD SEGMENT statement. The SET VOL statement adds a disk volume to a segment.
Each segment definition can have from one to eight SET VOL statements.
name
specifies the name of a disk volume. This device must exist.
$ldev
specifies the logical device number of a disk volume.
On NonStop Himalaya K-series servers,
$ldev allows you to specify the disk
volume if it was configured as a demountable device. Demountable devices do not
exist on NonStop Himalaya S-series servers.
$alt-name
specifies a syntactically valid device name that matches the name of the device
designated by $ldev.
Example
The following is an example of a full set of eight volumes for a segment. You must
specify at least one volume for each segment, or else a subsequent ADD SEGMENT
command is not allowed.
SET VOL $NOMAD0
SET VOL $NOMAD1
SET VOL $NOMAD2
SET VOL $NOMAD3
SET VOL $NOMAD4
SET VOL $NOMAD5
SET VOL $NOMAD6
SET VOL $NOMAD7
SET VOL { $name }
{ $ldev [ ( $alt-name ) ] }
Caution. Do not use the $ldev parameter. On NonStop Himalaya S-series servers, logical
device numbers are arbitrarily assigned to a device when you configure the device and every
time the system is loaded.