User Manual

NonStop AutoTMF Software Commands

HP NonStop AutoTMF Software User’s Guide—429952-014

6-80

STOP MONITOR

Performs an orderly shutdown of the monitor process.

process-name

specifies the name of the NonStop AutoTMF software monitor process to be

stopped. The default is the current monitor for the session.

mapdb

specifies the subvolume of a MapDB. This is an alternative method to specify the

process to be stopped.

STOP PROCESS

This command attempts to stop a process in a way that allows NonStop AutoTMF

software to commit all active automatic transactions. To stop a process, the command

must be issued by the user ID or the manager ID of the process creator, or by the

SUPER user.

ESCORT CI sends a special message to the process, so the process must be reading

$RECEIVE.

This command is intended to be used in emergencies where automatic transactions

are not being committed and you want to prevent transaction aborts and loss of data.

When the message is received, the automatic transactions are committed and the

process is abended. A message is written to the process home terminal and to the

EMS log.

cpu,pin | process-name

specifies the process id or name of the application process to be stopped.

TIME

Displays the current local time of day as obtained from the local Guardian timekeeping

function. You may also request the local time as seen by another system on your

Expand network.

systemname

identifies an Expand system for which the local system time is desired.

STOP MONITOR [ process-name | mapdb ];

STOP PROCESS { cpu,pin | process-name };

TIME [ systemname ];