User Manual

NonStop AutoTMF Software Commands
HP NonStop AutoTMF Software User’s Guide—429952-014
6-84
TRACE
process-spec
PROGRAM object-file-name | fileset
restrict tracing to a selected set of programs.
If this option is used in conjunction with the DEBUG option, the program must
be uniquely specified, not as a pattern.
PROCESS process-name | process-namelist | *
PROCESS cpu-pin
PROCESS cpu,*
restrict tracing to a selected set of processes.
If PROCESS is used with the DEBUG option, the process must be uniquely
specified (not as a pattern).
If PROGRAM or PROCESS are not specified, all prepared programs are traced.
option
CLEAR
purges the data in the trace file before writing the first trace entry.
DEBUG [ TERM term-name | MYTERM ]
starts the traced process in INSPECT and sends the INSPECT prompt to one
of the following locations:
•
to the terminal specified in the TERM option or,
•
if MYTERM is specified, to the home terminal of the CI session or,
•
if none is specified, to the home terminal of the process being debugged.
The DEBUG option can be specified only when tracing a single process; a
unique PROGRAM or PROCESS must be specified.
This option cannot be used for dynamic tracing.
EDIT
instructs NonStop AutoTMF software to create the trace file as an Edit file. If
this option is specified, only one process can open the trace file at a time.
FOR n
sets a time limit of n minutes for tracing, starting when the command is
entered. The default is 60 minutes. If n is set to 0, then there is no time limit.
When the time limit expires, the trace configuration is reset and processes
currently tracing with the configuration cease tracing.
SEPARATE