Operation Manual

Figure B-2 Back view of the printer
1 Telephone wall jack
2 DSL (or ADSL) lter and cord supplied by your DSL provider
3 Connect the phone cord to the port labelled 1-LINE on the back of the printer.
You might need to connect the phone cord to your country/region adapter.
To set up the printer with DSL
1. Obtain a DSL lter from your DSL provider.
2. Connect one end of the phone cord to the DSL lter, and then connect the other end to the port labeled
1-LINE on the back of the printer.
NOTE: You might need to connect the phone cord to your country/region adapter.
You might need to obtain additional phone cords for this setup.
3. Connect an additional phone cord from the DSL lter to the telephone wall jack.
4. Run a fax test.
If you encounter problems setting up the printer with optional equipment, contact your local service provider
or vendor for further assistance.
Case C: Set up the printer with a PBX phone system or an ISDN line
If you are using either a PBX phone system or an ISDN converter/terminal adapter, make sure you do the
following:
● If you are using either a PBX or an ISDN converter/terminal adaptor, connect the printer to the port that
is designated for fax and phone use. Also, make sure that the terminal adapter is set to the correct
switch type for your country/region, if possible.
162 Appendix B Additional fax setup ENWW