HP EliteBook 745 G2 HP Notebook PC and EliteBook 755 G2 Notebook PC - Maintenance and Service Guide
Table Of Contents
- Product description
- External component identification
- Illustrated parts catalog
- Removal and replacement procedures preliminary requirements
- Removal and replacement procedures for Customer Self-Repair parts
- Removal and replacement procedures for Authorized Service Provider parts
- Computer Setup (BIOS), TPM, and HP Sure Start in Windows 10
- Computer Setup (BIOS) and MultiBoot in Windows 8.1
- Computer Setup (BIOS) and MultiBoot in Windows 7
- Using Setup Utility (BIOS) in Ubuntu
- Using HP PC Hardware Diagnostics (UEFI)
- Backup and recovery in Windows 10
- Backup and recovery in Windows 8.1
- Backup and recovery in Windows 7
- Backing up, restoring, and recovering in Ubuntu
- Specifications
- Computer specifications–HP EliteBook 745 models
- Computer specifications–HP EliteBook 755 models
- 35.6 cm (14.0 in) HD SVA display specifications
- 35.6 cm (14.0 in) HD+ SVA display specifications
- 35.6 cm (14.0 in) FHD, UWVA display specifications
- 39.6 cm (15.6 in) HD SVA display specifications
- 39.6 cm (15.6 in) FHD SVA display specifications
- Hard drive specifications
- Solid-state drive specifications
- Statement of Volatility
- Power cord set requirements
- Recycling
- Index
Description Spare part number
15.6 in (39.6 cm) HD AG SVA 45% CG 200 nits (cd/m
2
) eDP 1.2 at (1366x768) for use in HP EliteBook
755 models
777834-001
Webcam module 777326-001
Microphone module 730795-001
Before removing the display assembly, follow these steps:
1. Turn o the computer. If you are unsure whether the computer is o or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the service door (see Service door on page 45).
5. Remove the battery (see Battery on page 47).
Remove the display panel:
1. Lift to disengage the bezel on the bottom (1), left and right sides (2), and top (3).
2. Remove the bezel from the display assembly (4).
3. Remove the four Phillips PM2.0×3.0 screws (1) that secure the display panel to the display enclosure.
Component replacement procedures 61