HP EliteBook 745 G2 HP Notebook PC and EliteBook 755 G2 Notebook PC - Maintenance and Service Guide
Table Of Contents
- Product description
- External component identification
- Illustrated parts catalog
- Removal and replacement procedures preliminary requirements
- Removal and replacement procedures for Customer Self-Repair parts
- Removal and replacement procedures for Authorized Service Provider parts
- Computer Setup (BIOS), TPM, and HP Sure Start in Windows 10
- Computer Setup (BIOS) and MultiBoot in Windows 8.1
- Computer Setup (BIOS) and MultiBoot in Windows 7
- Using Setup Utility (BIOS) in Ubuntu
- Using HP PC Hardware Diagnostics (UEFI)
- Backup and recovery in Windows 10
- Backup and recovery in Windows 8.1
- Backup and recovery in Windows 7
- Backing up, restoring, and recovering in Ubuntu
- Specifications
- Computer specifications–HP EliteBook 745 models
- Computer specifications–HP EliteBook 755 models
- 35.6 cm (14.0 in) HD SVA display specifications
- 35.6 cm (14.0 in) HD+ SVA display specifications
- 35.6 cm (14.0 in) FHD, UWVA display specifications
- 39.6 cm (15.6 in) HD SVA display specifications
- 39.6 cm (15.6 in) FHD SVA display specifications
- Hard drive specifications
- Solid-state drive specifications
- Statement of Volatility
- Power cord set requirements
- Recycling
- Index

RTC battery
Description Spare part number
RTC battery (includes cable and double-sided tape) 665733-001
Before removing the RTC battery, follow these steps:
1. Turn o the computer. If you are unsure whether the computer is o or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the service door (see Service door on page 45).
5. Remove the battery (see Battery on page 47.
Remove the RTC battery:
1. Disconnect the RTC battery cable (1) from the system board.
2. Slide the battery out from the bottom cover (2), and then remove the battery (3). (The RTC battery is
attached to the base enclosure with double-sided tape.)
3. Remove the RTC battery.
Reverse this procedure to install the RTC battery.
64 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts










