HP EliteBook 745 G2 HP Notebook PC and EliteBook 755 G2 Notebook PC - Maintenance and Service Guide
Table Of Contents
- Product description
- External component identification
- Illustrated parts catalog
- Removal and replacement procedures preliminary requirements
- Removal and replacement procedures for Customer Self-Repair parts
- Removal and replacement procedures for Authorized Service Provider parts
- Computer Setup (BIOS), TPM, and HP Sure Start in Windows 10
- Computer Setup (BIOS) and MultiBoot in Windows 8.1
- Computer Setup (BIOS) and MultiBoot in Windows 7
- Using Setup Utility (BIOS) in Ubuntu
- Using HP PC Hardware Diagnostics (UEFI)
- Backup and recovery in Windows 10
- Backup and recovery in Windows 8.1
- Backup and recovery in Windows 7
- Backing up, restoring, and recovering in Ubuntu
- Specifications
- Computer specifications–HP EliteBook 745 models
- Computer specifications–HP EliteBook 755 models
- 35.6 cm (14.0 in) HD SVA display specifications
- 35.6 cm (14.0 in) HD+ SVA display specifications
- 35.6 cm (14.0 in) FHD, UWVA display specifications
- 39.6 cm (15.6 in) HD SVA display specifications
- 39.6 cm (15.6 in) FHD SVA display specifications
- Hard drive specifications
- Solid-state drive specifications
- Statement of Volatility
- Power cord set requirements
- Recycling
- Index
Internal base enclosure
Internal base enclosure removal procedures for HP EliteBook 745 models and HP EliteBook 755 models are in
separated in the following sections.
Internal base enclosure (HP EliteBook 745 models)
Description Spare part number
Internal base enclosure for use only on HP EliteBook 745 models 779684-001
Before removing the internal base enclosure, follow these steps:
1. Turn o the computer. If you are unsure whether the computer is o or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the following components:
a. Service door (see Service door on page 45)
b. Battery (see Battery on page 47)
c. Keyboard (see Keyboard on page 56)
Use the following image as an overview of all internal base enclosure screw locations.
Remove the internal base enclosure:
1. Position the computer upside down.
Component replacement procedures 65