Installation Instructions

Laser Compliance
This device is classified as a Class 2 Laser Product in accordance with
US FDA regulations and the IEC 60825-1.
Each laser product complies with 21 CFR 1040.10 and 1040.11
except for deviations pursuant to Laser Notice No. 50, dated June 24,
2007; and with IEC 60825-1:2007
CAUTION: CLASS 2 LASER RADIATION DO NOT STARE INTO
THE BEAM
Output Radiation 1mW Avg. Emitted Wave Length 650nm
WARNING! Use of controls or adjustments or performance of
procedures other than those specified herein or in the laser
product's installation guide may result in hazardous radiation
exposure. To reduce the risk of exposure to hazardous radiation:
• Do not try to open the module enclosure. There are no user-
serviceable components inside.
• Do not operate controls, make adjustments, or perform
procedures to the laser device other than those specified herein.
• Allow only HP Authorized Service technicians to repair the unit.
HP RP7 Retail System Model 7100
CAUTION: You must rotate antenna
brackets up to remove front panel.
NOTE: Tightening the security screw
is optional.
NOTE: This step may not be necessary if
the security screw is already loosened.