Operation Manual

5. Put the tray into the product.
Load optional Tray 3
Tray 3 is an optional accessory tray that attaches to the bottom of the product. It can hold longer media, such
as legal (216 x 356 mm, 8.5 x 14 inches) paper.
NOTE: If you are not using Alternate Letterhead Mode (ALM), place the paper with the side to be printed on
face-up, with the top edge toward the left side of the tray. For ALM orientation, see Load letterhead or
preprinted forms .
1. Pull the tray out of the product.
2. Open the paper length and width guides completely.
3. Place the paper in the tray and make sure that it is at at all four corners. Close the length and width
paper guides against the loaded media.
48 Chapter 4 Paper and print media ENWW