Quick Start Manual

Quick Start Guide

Filename: ma3ubqs.doc Title: HP-Print2k.dot

Template: HP-Print2K.dot Author: JimL Last Saved By: kimt

Revision #: 36 Page: 11 of 148 Printed: 04/03/03 02:04 PM

Start Here

To use the multi-storage bay for a

peripheral device, do the

following:

1 Open the bay cover. Hold the

cover on each side near the

hinges, then lift the cover and

slide it toward the back of the

chassis (figure C). Gently lift

it off.

2 Thread the cables through the

cable tunnel opening at the back

of the bay (figure D). Connect

data and power cables to the

peripheral device, and place

the peripheral in the bay.

3 Connect the data cable to the

USB or FireWire (IEEE 1394)

connector on the back of the

PC. Plug the power cord into

a power outlet.

Your PC may look different from

the one shown here. Component,

connector location, type, and

number vary by model.

Multi-Storage Bay — Peripheral Placement