Quick Start Manual

xii
HP Pavilion home PC
Filename: ma3ubqs.doc Title: HP-Print2k.dot
Template: HP-Print2K.dot Author: JimL Last Saved By: kimt
Revision #: 36 Page: 12 of 148 Printed: 04/03/03 02:04 PM
To use the chassis top to set a
peripheral device, do the following:
1 Remove the bay cover (see step 1
on previous page).
2 Grasp the tab and pull it out
toward the front of the chassis
(figure E). Put the tab in its
storage area in the bay near the
spindle (figure F).
3 Thread the data and power
cables for the device through the
cable tunnel opening at the back
of the bay. Place the cables in the
tab opening and replace the bay
cover. Close the cover.
4 Connect the cables to the device,
and place it on the top of the
chassis (figure G). At the back of
the PC, connect the data cable to
the USB or FireWire (IEEE 1394)
connector on the back of the PC.
Plug the power cord into a power
outlet.
Multi-Storage Bay — Peripheral Placement (Continued)
E
F
G