Quick Start Manual

34
HP Pavilion home PC
Filename: ma3ubqs.doc Title: HP-Print2k.dot
Template: HP-Print2K.dot Author: JimL Last Saved By: kimt
Revision #: 36 Page: 34 of 148 Printed: 04/03/03 02:04 PM
To configure multi-channel audio
output for the DVD player
Note: WinDVD is set up for two (stereo) speaker output.
To hear all speakers on multi-channel DVD movies,
change the audio properties for WinDVD so that
they match your speaker configuration (set in the
previous procedure) and the recorded DVD
capability.
1 Insert a DVD or start InterVideo WinDVD
Player. (See ”Playing a DVD” on page 75.)
2 Right-click anywhere in the WinDVD video
window, and then click Setup.
3 Click the Audio tab.
4 Click the option for the number of speakers
that matches your multi-channel speaker
system. Click Apply.
You can then test the speakers: click the Test
button and the WinDVD control panel shows
the speaker number being used. Click Stop.
5 Click OK.
Note:
If you want to play a stereo DVD, repeat
these steps (1 through 5) and change the
audio properties for WinDVD to match the
DVD output.
To use the microphone
with multi-channel audio
The multi-channel speaker system connects to
the PC using the Microphone, Audio (Line) In,
and Audio (Line) Out connectors on the back
of the PC.
Your PC may have another microphone
connector in the front of the PC under the
access door. If present, this microphone
connector is ready to use.
To use the back microphone connector, you
must disconnect your multi-channel speakers
system and select 2-channel audio setup.
To change the audio configuration, see
“To configure multi-channel audio output
for speakers configuration” on page 33.