Quick Start Manual

Quick Start Guide
63
Filename: ma3ubqs.doc Title: HP-Print2k.dot
Template: HP-Print2K.dot Author: JimL Last Saved By: kimt
Revision #: 36 Page: 63 of 148 Printed: 04/03/03 02:04 PM
Common Tasks
Each card slot has its own drive letter and icon.
When you insert media, the display label may
change to the title of the media, if the title is
present.
Special note about the Safely
Remove Hardware Utility
Warning:
Do not click Stop in the
Safely Remove Hardware window with
the USB Mass Storage Device selected.
Doing so removes the operating system
recognition of the 6-In-1 memory card
reader from your PC; you must restart
the PC to see your reader again.
If you open the Safely Remove Hardware
window by mistake, click Close.
To use the 6-In-1
memory card reader
Important: CompactFlash and Microdrive are keyed
and cannot be inserted incorrectly. Insert the
receptacle edge (holes) of this media into the slot.
For the two-slot reader, the Secure Digital (SD)
card, the MultiMediaCard (MMC), and the
Memory Stick (MS) card must be inserted upside
down (gold connector fingers face up). Note the
direction of the notched corner on the media.
1 Insert the media into the card slot until it stops.
The in-use light (A) on the card reader lights,
and the PC automatically detects the media.
2 The PC opens a window so you can access
the media contents. You can copy files from or
to the media.
3 When you are done, right-click the drive icon,
select Eject, check that the in-use light is on
but not blinking, and then remove the media.
A steady light indicates that the PC is not
accessing the media.