Quick Start Manual

Quick Start Guide
87
Filename: sa3rwqsK.doc Title: HP-Print2k.dot
Template: HP-Print2K.dot Author: AnnSchmidt Last Saved By: JimL
Revision #: 218 Page: 87 of 126 Printed: 10/22/02 01:21 PM
Recovery
9 Press the Eject button on the top CD-ROM
drive, and wait for the tray to open. Insert
Recovery CD #1 and close the tray.
10 Press the F10 key to save the changes and
exit BIOS.
11 With Yes selected, press Enter.
12 The PC starts the recovery; wait for the
onscreen instructions to display, and then
follow those instructions:
■
For standard recovery, press R, and then
press R again. Click Next to proceed
with the non-destructive system recovery.
Click Yes to start the recovery. Insert the
remaining CDs when directed.
Or
■
If your PC hard disk drive is blank or
corrupted, press R to perform a full system
recovery. Insert the remaining CDs when
directed.
13 When the recovery program finishes, click
Restart to restart the computer.
14 Before the computer restarts, the CD tray
ejects. Remove the CD.
15 Return the BIOS to the original setting. Enter
the BIOS setup program during the startup:
When the blue screen with the HP Invent logo
appears, press the F1 key on the keyboard
until Entering SETUP is displayed. (You only
have a few seconds to press the F1 key
before the normal startup process continues.)
Wait until the BIOS setup program opens.
16 Press the right arrow key to select Boot.
17 Press the down arrow key to select
Boot Device Priority, and then press Enter.