Troubleshooting and Maintenance Guide

20 Troubleshooting and Maintenance Guide
Miscellaneous
Symptom Possible solution
Insufficient memory message
displays.
Close all open programs, and then try the desired task
again, or restart your computer (click the Windows Start
Button, click the Arrow button next to the Lock button,
and then click Restart). If the message displays again,
consider purchasing and installing additional memory.
Remote sensor is not receiving
a signal from the remote
control (select models only).
1 Click the Windows Start Button, right-click Computer, and then
select Properties.
2 Under Tasks, click Device Manager.
3 Click the plus (+) sign next to Universal Serial Bus Controllers.
4 If the eHome Infrared Receiver is listed under Universal Serial Bus
Controllers, Windows Vista is properly detecting the IR Receiver. If it is not
listed, go to the next step.
5 Unplug the end of the USB cable on the remote sensor from the computer
and plug it into the same USB port.
6 Disconnect all other USB devices, leave the remote sensor plugged in, and
then restart the computer. Plug in other USB devices after the remote sensor
appears in the Device Manager window.
Memory card reader (select
models only) cannot read my
memory card.
Do not insert or remove memory cards when the in-use light is flashing. To do
so may cause data loss, or it may permanently damage the card reader.
Some cards have a Read/Write or Security switch on the card. Make sure the
switch is set to Write Enabled before attempting to write data to it.
Make sure the amount of data you are storing has not exceeded the storage
limit of the card.
Make sure the memory card is one of the supported types: CompactFlash (I, II,
and Microdrive), Memory Stick, Memory Stick Pro, MultiMedia, Secure
Digital, SmartMedia, or xD. Some models may support additional types.
Make sure the memory card is fully inserted into the correct slot.
Inspect the ends of the memory cards for dirt or material closing a hole or
spoiling a metal contact. Clean the contacts with a lint-free cloth and small
amounts of isopropyl alcohol. Replace the memory card if necessary.