User Manual

Hardware options installation 53
2.
Slide the power supply into the power supply bay until the release/lock lever clicks, securing the
power supply.
3. Connect the power cord to the power supply.
4. Tighten the two retaining screws on either side of the power cord connector.
5. Route the power cord:
o If the cable management arm has a left-hand swing, route the power cord through the cable
management arm.
o If the cable management arm has a right-hand swing, remove the cable management arm or
convert it for left-hand swing. For removal instructions, see "Cable management arm with right-
hand swing (on page 27)." For conversion instructions, see the instructions that ship with the 2U
Quick Deploy Rail System.
6. Connect the power cord to the DC power source.
7. Be sure that the power supply and external health LEDs are illuminated green.
Expansion board options
The server supports PCI, PCI-X, and PCI Express expansion boards.
Installing an expansion board (slot 2)
1. Power down the server (on page 23).
2. Extend the server from the rack (on page 23).
3. Remove the access panel (on page 24).