User's Manual

3 Using the web interface to view Moonshot System details
This chapter provides information about viewing the available information using Moonshot web
interface.
Using the iLO CM firmware web interface
You can use the iLO CM firmware web interface to manage the HP Moonshot System. You can
also use the iLO CM firmware command line.
Browser support
The iLO CM firmware web interface requires a browser that supports JavaScript. For a list of
supported browsers, see Table 1 (page 11).
Table 1 Supported browsers
ChromeFirefoxInternet ExploreriLO CM firmware version
Chrome (latest version)ESR 24111.30
If you receive a notice that your browser does not have the required functionality, verify that your
browser settings meet the following requirements, or contact your administrator.
The following settings must be enabled:
• JavaScript—The iLO CM firmware web interface uses client-side JavaScript extensively.
• Cookies—Cookies must be enabled for certain features to function correctly.
• Pop-up windows—Pop-up windows must be enabled for certain features to function correctly.
Verify that pop-up blockers are disabled.
Logging in to the iLO CM firmware web interface
You must access the iLO CM firmware web interface through HTTPS (HTTP exchanged over an SSL
encrypted session).
To log in to the iLO CM firmware web interface:
1. Enter https://<iLO CM firmware host name or IP address>.
The login page opens.
2. Enter an iLO CM firmware user name and password, and then click Login.
Login problems might occur for the following reasons:
• You recently upgraded the iLO CM firmware. You might need to clear your browser cache
before attempting to log in again.
• You entered incorrect login information.
Passwords are case sensitive.◦
◦ User names are not case sensitive. Uppercase and lowercase characters are treated the
same (for example, Administrator is treated as the same user as administrator).
• Your user account is not a valid iLO CM firmware account.
• Your user account has been deleted, disabled, or locked out.
• The password for the user account must be changed.
After an initial failed login attempt, the iLO CM firmware imposes a security delay of ten seconds.
Each subsequent failed attempt increases the delay by ten seconds.
Using the iLO CM firmware web interface 11