Specifications

Removal and Replacement Procedures

Hot-Plug Hard Drive Blank

NOTE: The server does not need to be powered off to complete this operation.

To remove a hot-plug hard drive blank:

1. Open the bezel door. Refer to “Bezel Door (Tower Model Only)” earlier in this chapter.

2. Slide the release latch to the left (1), and then pull the hot-plug drive blank out of the

drive bay (2).

Figure 2-17: Removing a hot-plug hard drive blank

To replace a hot-plug hard drive blank, reverse steps 1 and 2.

2-20 HP ProLiant ML350 Generation 3 Server Maintenance and Service Guide