Specifications
Table Of Contents
- HP ProLiant ML350 Generation 4 Server Maintenance and Service Guide
- Notice
- Contents
- Illustrated parts catalog
- Removal and replacement procedures
- Required Tools
- Safety considerations
- Preparation procedures
- Removing tower feet
- Removing the front bezel (tower model)
- Rack rails
- Removing the power supply blank
- Hot-plug power supply
- Non-hot-plug power supply
- Hot-Plug Power Supply Backplane
- Removing a hard drive blank
- Hot-Plug SCSI Hard Drive
- Non-hot-plug SCSI hard drive
- Redundant system fan
- Expansion Slot Cover
- Expansion board
- CD-ROM drive
- Tape drive
- Internal two-bay hot-plug SCSI drive cage
- Processor and Heatsink
- PPM
- Second serial port
- Duplex SCSI backplane
- Battery
- System Board
- Re-entering the server serial number and product ID
- Diagnostic tools
- Server component identification
- Specifications
- Acronyms and abbreviations
- Index
Removal and replacement procedures 24
Processor and Heatsink
IMPORTANT: If upgrading processor speed, update the system ROM before installing the processor.
IMPORTANT: PPM 2 must be installed when processor 2 is installed. The system fails to boot if the PPM is
missing.
To remove a processor and heatsink:
1. Remove the access panel ("Access Panel" on page 12).
2. Disconnect the heatsink connectors from the headers on the system board ("System Board
Components" on page 40).
3. Open the heatsink retaining levers.
4. Remove the heatsink.